PROMOTER INFO –  TUCKER CENTER ARENA

Wall to Wall – 86' x 206' 
Bleachers Extended – 67' x 147' 

Load-in for the arena is accomplished through a 16' x 15' roll-up door in the southwest corner of the arena. Any equipment requiring a loading height greater than 14’ must be advanced in order to adjust the interior curtain clearance. Loading for additional trucks is possible through two (2) 13’ 6" H x 10’ W doors in a backstage area located 40’ south of the main load-in door. However, direct passage to the arena from this location is restricted by a width of 6’ 10".

Note: All capacities are subject to change depending on the event requirements. Capacities do not take into account production kills including the mix.

East/west beams on 30’ centers run the width of the arena.

One center North/South beam runs the length of the arena.

• Please note: this beam cannot be used for rigging

All rigging steel is 87’ above the arena floor.

Each beam can hold a maximum weight of 20,000 pounds, with a per point maximum of 5,000 pounds. 

Obstructions:

• One 30' x 30' center scoreboard.

Show power is located in the SW corner of the Arena - Bottom of Section 105

• (1) 600 amp, 208 volt, 5 wire service
• (1) 400 amp, 208 volt, 5 wire service
• (2) 200 amp, 208 volt, 5 wire service
• Additional power - N/S Transfer Hallway at NW Corner of Arena
  • (1) 200 amp, 208 volt, 5 wire service
• Power connections are all camlock
• No shore power is available

Note: Additional meetings rooms may be available on advance with Event Manager.